OPERATOR’S MANUALCOMPOSITE DAVIT CRANE Model# OZ1200DAVWorking Load: 1200 lbs. *See load rating table on pg.13Please read the Owner’s Manual carefully
pg.10Operating the CraneWarnings & PrecautionsOperators should read and fully comprehend this entire manual and all warnings on the CompOZite Davi
Loads are normally lifted by use of the manual winch that is supplied on the crane. In some instances (e.g. to lift over a parapet), the ratchet binde
pg.12DenitionsDesignated Person - The person who is selected or assigned as being competent to perform specic duties.Qualied Person - The person th
pg.13Inspection ChartNOTE: Disassemble crane including ratchet jack, boom, and winch periodically to inspect each for damage. Use the following chart
pg.143/16” CableBoom Position 1Boom Position 2Boom Position 3Boom Position 46 ft. 800 lbs. 800 lbs. 700 lbs. 400 lbs.14 ft. 800 lbs. 800 lbs. 700 lbs
pg.15Troubleshooting ChartContact OZ Lifting Products LLC® if disassembly of the crane is required. The warranty will be voided if this is not done.Pr
5455 W. 6th St.P.O. Box 845Winona, MN 55987Phone (800) 749-1064(507) 474-6250Fax (507) [email protected]
pg.2Table of ContentsPg. 3 ...One-Year Limited WarrantyPg. 4 ...Product Precautions Pg. 5 ...
pg.3One-Year Limited WarrantyAll OZ Lifting Products LLC® are guaranteed to be free of defects in materials and workmanship for one year from the date
Product PrecautionsThe information in this manual should be used only for the CompOZite Davit Crane. This manual contains general instructions for nor
pg.5Safety WarningsDo Not lift any load that is not located directly below the crane. This product is not intended to drag a load sideways. Do Not wra
pg.6The safety lanyard is not designed to be load bearing. It CANNOT be used in place of the supplied ratchet binder.At no point during a lift should
Assembling the CranePre-AssemblyPlease refer to the Parts Diagram on pg. 9 before assembling the crane.Inspect the crane to assure there are no missin
5. Insert the small telescoping boom section into the larger boom section. Align holes at desired extension and insert the remaining clevis pin #1. Se
Assembly Diagrampg.91.4.7.2.5.8.3.6.9.
Commentaires sur ces manuels